Icom IC-2710H

13
PAGER AND CODE SQUELCH
58
■ Code programming
➀ Push the desired band’s tuning dial.
• Each band has separate code channels.
➁ Push [DTMF] 2 times to turn the pager function ON.
•“P” appears in place of the 100 MHz digit.
➂ Push [(VOL)SET] to select the code channel setting display.
➃ Rotate the selected band’s tuning dial to select the desired
code channel, 0–5.
• Code channel P cannot be used for programming.
➄ Push [(SQL)MONI] or [(VOL)SET] to select the digit to be
programmed.
➅ Rotate the selected band’s tuning dial to set the digit.
➆ Repeat ➄ and ➅ until the last digit is programmed.
➇ Push [DTMF] to set the code channel for “receive inhibit”
or “receive accept.”
• When “receive inhibit” is set, “” appears.
• Code channel 0 cannot be set as “receive inhibit.”
• See p. 57 for “receive inhibit” or “receive accept” details.
➈ Push the selected band’s tuning dial to exit the setting dis-
play.
SKIP
159
The display shows that
VHF code channel 0
(your ID code) is pro-
grammed for 248.
Ä Push [BAND] to select the desired band, if nec-
essary.
• Each band has separate code channels.
Å Push [FUNC] then [➃PGR] to turn the pager
function ON.
•“P” appears in place of the 100 MHz digit.
Ç Push [FSET] to select the code channel setting
display.
É Push [Y] or [Z] to select and set the desired
code channel, 0–5.
• Code channel P cannot be used for programming.
Ñ Push the numeral keys to enter the desired
3-digit code.
• Digits are automatically stored once the 3rd digit has
been entered.
Ö Push [FSET] to set the code channel for “re-
ceive inhibit” or “receive accept.”
• When “receive inhibit” is set, “” appears.
• Code channel 0 cannot be set as “receive inhibit.”
• See p. 57 for “receive inhibit” or “receive accept” de-
tails.
Ü Push [ECLR] to exit the setting display.
SKIP
SET
B
IC-2710H.qxd 02.2.8 16:55 Page 58 (1,1)