3
SETTING A FREQUENCY
18
■ Tuning step selection
Tuning steps are the minimum frequency change increments
when you rotate the tuning dial or push the [Y] or [Z]
switches on the microphone. The following tuning steps are
available:
• 5 kHz • 10 kHz • 12.5 kHz • 15 kHz
• 20 kHz • 25 kHz • 30 kHz • 50 kHz
NOTE: For convenience, select a tuning step that
matches the frequency intervals of repeaters in your area.
➀ Push the desired band’s tuning dial.
➁ Push the selected band’s [V/MHz] to select VFO mode if
another mode has been selected.
➂ Push the selected band’s [
(VOL)SET] one or more times
until “tS” appears as shown below.
• Pushing [(SQL)MONI] reverses the order of selection.
• Cancel the DTMF memory or optional pager/code squelch in ad-
vance. (pgs. 49, 59, 62)
➃ Rotate the selected band’s tuning dial to select the tuning
step.
➄ Push the selected band’s tuning dial to exit set mode.
Ä Push [BAND] to set the main band, if neces-
sary.
Å Push [VFO] to select VFO mode.
Ç Push [FSET] one or more times until “tS” ap-
pears as shown previously.
• Push [ENT] to reverse the order of selection.
• Cancel the DTMF memory or optional pager/code
squelch in advance. (pgs. 49, 59, 62)
É Push [Y] or [Z] to select the tuning step.
Ñ Push [CLR] to exit set mode.
USING
SET MODE
To Next Page
Loading...
