Icom IC-2710H

6
MEMORY OPERATION
34
■ Programming a memory channel via the microphone
Memory channel programming can be performed
via the microphone.
Ä Push [BAND] to select the desired band, if necessary.
Å Set the desired frequency in VFO mode:
➥ Push [VFO] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data (e.g. offset frequency, duplex direction, subaudi-
ble tone encoder ON/OFF and its frequency), if required.
MW
Ç Push [FUNC] then [EMW] momentarily.
É Select the memory channel to be programmed:
➥ Push [Y] or [Z] to select the memory channel (direct numeral
input cannot be used).
Ñ Push [FUNC] then [EMW] for 1 sec. to program.
➥ 3 beeps may sound and the VFO contents (including the sub-
audible tone frequency, etc.) are programmed.
➥ Memory channel number advances when continuing to push
[MW] after programming.
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 via the microphone.
159
159159
Push , Push then
momentarily
PushPush for 1 sec. and
continue pushing
BAND VFO
8
DUP+
7
DUP
5
MID
1
MONI
4
HIGH
C
ENT
MW
FUNC
A
CLR
then
MW
FUNC A
CLR
IC-2710H.qxd 02.2.8 16:55 Page 34 (1,1)