Icom IC-2710H

6
MEMORY OPERATION
35
■ Transferring memory
contents
This function transfers a memory channel’s contents into a VFO
(or another memory/call channel). This is useful when search-
ing for signals around a memory channel frequency and for re-
calling the offset frequency, subaudible tone frequency, etc.
➀ Push the desired band’s tuning dial.
➁ Select the memory channel to be transferred:
➥ Select memory mode by pushing the selected band’s [M/CALL]
once or twice (“!” appears).
➥ Rotate the selected band’s tuning dial to select the memory
channel.
➂ Push [S.MW] momentarily, then rotate the tuning dial to se-
lect another memory channel to transfer.
• To transfer to the VFO, push and hold [
(S.MW)MW] instead of
pushing momentarily.
➃ Push and hold [(S.MW)MW] to transfer when a momentary
push was used in the previous step.
DUP
–
T
DUP
–
T
S.MW MW
Push
+
for 1 sec.
MW
FUNC
A
CLR
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Select the memory channel to be transferred:
➥ Push [MR] to select memory mode.
➥ Push [Y] or [Z] to select the memory channel; or
push [GENT] then push the desired memory chan-
nel number (2 digits) to select the memory channel
directly.
Ç Push [FUNC] then [EMW] momentarily, then
push [Y] or [Z] to select another memory chan-
nel to transfer.
• To transfer to the VFO, push [FUNC] then push and
hold [EMW] instead of pushing momentarily.
É Push [FUNC] then [EMW] for 1 sec. to transfer
when a momentary push was used in the pre-
vious step.
MW
IC-2710H.qxd 02.2.8 16:55 Page 35 (1,1)