7
CALL CHANNEL OPERATION
38
■ Programming a call channel
In addition to an operating frequency, duplex information and
subaudible tone information (tone encoder or tone squelch*
ON/OFF and its frequency) can be programmed into the call
channel.
*An optional UT-104 is necessary.
➀ Push the desired band’s tuning dial.
➁ Select the call channel by pushing the selected band’s
[M/CALL] once or twice. (A large “C” appears.)
➂ Set the desired frequency in VFO mode:
➥ Push [VFO] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data (e.g. offset frequency, duplex direction, subaudi-
ble tone encoder ON/OFF and its frequency), if required.
➃ Push [(S.MW)MW] for 1 sec. to program.
[EXAMPLE]: Programming 145.120 MHz into the VHF call channel via the microphone.
✔ CONVENIENT
The call channel can also be programmed from the VFO di-
rectly (similar to memory programming).
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Push [(MR)CALL] for 1 sec. to select the call
channel.
Ç Set the desired frequency in VFO mode:
• Push [VFO] to select VFO mode.
• Set the desired frequency using the keypad.
• Set other data, if required.
É Push [FUNC] then [EMW] for 1 sec. to pro-
gram.
To Next Page
Loading...
