Icom IC-2710H

10
PRIORITY WATCH
48
■ Priority watch operation
➀ Push the desired band’s tuning dial.
➁ Select VFO mode; then, set an operating frequency.
➂ Set the watching channel(s).
For memory channel watch:
Select the desired memory channel.
For memory scan watch:
Select memory mode; then, push [
(V/MHz)SCAN] for 1 sec.
to start memory scan.
For call channel watch:
Select the call channel by pushing the selected band’s
[M/CALL] once or twice.
➃ Push the selected band’s [
(M/CALL)PRIO] for 1 sec. to start
the watch.
• The transceiver checks the memory or call channel frequency
every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 46)
• While the watch is pausing, pushing the selected band’s
[M/CALL] resumes the watch manually.
➄ Push the selected band’s [M/CALL] while the display
shows the VFO frequency to stop the watch.
PRIO
While pausing on the
memory or call chan-
nel, “PRIO” flashes.
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Select VFO mode; then, set an operating fre-
quency.
Ç Set the watching channel(s).
For memory channel watch:
Push [MR] then [Y] or [Z] to select the desired
memory channel.
For memory scan watch:
Push [MR] then [➁SCAN] to start the memory
scan.
For call channel watch:
Push and hold [
(MR)CALL] to select the call
channel.
É Push [➂PRIO] to start the watch.
• The transceiver checks the memory or call channel
frequency every 5 sec.
• The watch resumes according to the selected scan
resume condition. (p. 46)
• To resume the watch manually while pausing, push
[➂PRIO] or [ECLR].
Ñ To stop the watch, push [ECLR] once (or twice
while watch pauses).
PRIO
3
IC-2710H.qxd 02.2.8 16:55 Page 48 (1,1)