■ Scan start/stop
D Pre-operation
• Common setting: scan resume condition. (p. 46)
• For programmed scan: program the scan edges. (p. 43)
• For memory scan: program 2 or more memory chan-
nels; set memory skip settings, if de-
sired. (p. 45)
D Operation
➀ Push the desired band’s tuning dial.
➁ Select VFO mode for full/programmed scan; or memory
mode for memory scan with the selected band’s [V/MHz]
switch.
➂ Set the selected band’s squelch to the point where noise
is muted.
➃ Push [(V/MHz)SCAN] for 1 sec. to start the scan.
• When the optional tone squelch is in use, [(V/MHz)SCAN] starts
the tone scan.
• To change the scanning direction, rotate the selected band’s tun-
ing dial.
• The memory channel readout indicates the scan type as follows:
9
SCAN OPERATION
42
➄ To select the scan range while operating full/programmed
scan, push [SET] several times.
➅ To stop the scan, push [
(VMHz)SCAN].
Ä Push [BAND] to select the desired band, if nec-
essary.
Å Push [VFO] to select VFO mode for full/pro-
grammed scan; or push [MR] to select memory
mode for memory scan.
Ç Push [HYSQL] or [AZSQL] one or more times
to set the squelch just closed.
É Push [➂SCAN] to start the scan.
• [Y]/[Z] also start the scan when pushed and held.
Ñ To select the scan range while operating
full/programmed scan, push [SET] several
times.
Ö To stop the scan push [ECLR].
To Next Page
Loading...
