PAGER AND CODE SQUELCH
13
56
■ Pager function
The pager functions can be used only when an optional
UT-49 is installed. This function uses DTMF codes for paging
and can be used as a “message pager” to inform you of a
caller’s identity even if you leave the transceiver temporarily
unattended.
Personal calls and group calls are available with the pager
function. Personal calls use the receiving parties’ ID code for
calling. The receiving parties’ display shows your ID code and
other stations in the party know that you called.
Group calls use the group code for calling. All station displays
show the group code and all stations know that someone in
your group called.
To use the pager function in your group, all stations need the
pager function.
PAGER SIMULATION: Personal call PAGER SIMULATION: Group call
optional UT-49
IC-2710H.qxd 02.2.8 16:55 Page 56 (1,1)
To Next Page
Loading...
