IDS 400

IDS Base Station Receiver 400 700-179-02B Issued January 2009 29
4.
4.4.
4. P
PP
Program
rogramrogram
rogram M
M M
Mode
odeode
ode
The program mode is the means for the user to setup the IDS Base Station Receiver to suit the user’s
system configuration.
NOTE:
 The formats of the Program Mode displays are different between Base Control card version
V1.01 and lower and V1.02 upwards. The functions, however, are the same.
 The order of the Firmware menu has changed and only appears once for version V1.02 and up.
 The following program fields are not available on version V1.01 and lower.
• Event Date/Pre/Post
• Poll Date /Pre/Post
• LOAD DEFAULTS
Press Key 7
to view
Trouble Display
LINE CARD ABSENT
AC LOSS
LOW SYSTEM BATTERY
COMMS ABSENT
PRINTER ERROR
LINE TROUBLE
CONT ID
Contact ID
AE DTMF Ademco Express
4/2 WP FBI 4 by 2, With Parity
4/2 NP FBI 4 by 2, No Parity
SESC SF Sesco Superfast
SIA Security Industry Association
4/1
4 by 1
Format
3/1 NP
3 by 1 Format
ERROR
Received record or parity error
MISSED CALL No response to handshake
System MSG
BSR detected TROUBLE Conditions
Or Restorals
Event Format Recieved From Alarm Panel
RS232
9600 Baud
8 Bits
No Parity
1RRLssssssACCTsXssYY[DC4] - Basic Protocol
1RR0sssssssssss@ssss[DC4] - Hart Beat
5RRLs18AAAAQXYZGGCCC[DC4] - Contact ID
1RR0ssssss0000sXssYY[DC4] - Status Codes
4x2 Format
123456789ABCDEF
( X user chr)
ACCT6F
See Table 1 Format Discription.
See Tab
le 2 Trouble Condition
See 3.8.9 Basic Signal Protocol to 3.8.11
Line
Break