IDS Base Station Receiver 400 700-179-02B Issued January 2009 18
3.2.2.2
3.2.2.23.2.2.2
3.2.2.2
Move 20 Events Up/Down
Move 20 Events Up/DownMove 20 Events Up/Down
Move 20 Events Up/Down
This function moves/jumps/skips 20 events up or down at a time. To use this feature hold down the 6
or 5 key for two seconds, the event number at 123 + or – 20 will be displayed depending on the key
pressed, i.e. number 143 or 103.
3.2.3
3.2.33.2.3
3.2.3
Version Display, Print and Serial Output Facility
Version Display, Print and Serial Output FacilityVersion Display, Print and Serial Output Facility
Version Display, Print and Serial Output Facility
Control card version 3.00 and higher can display the installed control card and line card’s software
version. In addition to this the user may re-print events or re-send events to the monitoring program by
selecting a period for either or both of these two features to be enabled in the program mode, see 4.4.1
Enable Printer M201 and 4.6.2 Enable Serial M411. There is also a secondary serial print formatted output
facility of the event log on the Sin
SinSin
Sin port if it is not been used for base-to-base serial communications. To
select the facility, assuming the printer and the serial output period has been enabled:
Press the # key activates the facility then followed by the 5 or 6 to scroll through to the
desired function.
03 DEC 2000 16:48
Unit in Standby
Ver?
Press the * key to select the version display.
03 DEC 2000 16:48
Unit in Standby
Sout
Press the * key to select serial output to the monitoring program.
03 DEC 2000 16:48
Unit in Standby
Prnt
Press the * key to select the output to the printer.
03 DEC 2000 16:48
Unit in Standby
Stxt
Press the * key to select print format output on the serial port.