IDS 400 User Manual

IDS Base Station Receiver 400 700-179-02B Issued January 2009 38
Activate a thirty minute re-send/print period by entering [05...99] as described above.
PRINTER
Ena Print Log n Evnt
(30)
M201
Exit the Program mode.
4.4.1.2
4.4.1.24.4.1.2
4.4.1.2 Re
ReRe
Re-
--
-print or Re
print or Reprint or Re
print or Re-
--
-send Serial Text
send Serial Textsend Serial Text
send Serial Text
Once the printer or serial text output modes and the active period have been selected the re-send to the
printer or serial in ports may commence.
NOTE 1:
The operation from the “Standby Mode” will not function if the print function is disabled, the setting is set
to 00, make sure that one of the options [01...04] are selected prior to selecting an active period. Once
the period is selected, the remaining time will be displayed until it times out or is overwritten
NOTE 2:
The selected printer options [01...04] will remain selected after the selected period times out.
19-JUL-2006 08:30
LC1 CONT ID 1234
Panic
Event E120 00001 GOTO
 Press # , GOTO appears on the right hand side of the bottom line, press # again on Ver
3.12 > or 5 or 6 key, on earlier versions, until Prnt or Stxt appears.
19-JUL-2006 08:30
LC1 CONT ID 1234
Panic
Event E120 00001 Stxt
 Press * keys to select and then enter the number of events you wish to re-send 010 and
press * keys to initiate the output.
19-JUL-2006 08:30
LC1 CONT ID 1234
Panic
Event E120 00001 010
The selected number of event will be output on the Sin serial port or Printer port depending on the
selection made above.

IDS 400 Specifications

General

Brand	IDS
Model	400
Category	Receiver
Language	English