1-12
2
122
IEI
®
Technology, Corp.
Enabled
ESCD will be reconfigured after you exit setup
Resources Controlled By [Auto (ESCD)]
The Resources Controlled By option gives you the option of manually configuring all the
boot and plug and play devices, or allowing BIOS to configure these devices automatically.
If you allow BIOS to configure it automatically you will not be able to select the IRQs, DMA
and memory base address fields because BIOS will automatically assign them.
Auto(ESCD)
(D
EFAULT) BIOS automatically configures plug and play
devices as well as boot devices.
Manual
You manually configure the plug and play devices
and any other boot devices
x IRQ Resources [Press Enter]
If you select manual in the Resources Controlled By option then you will be able to
configure the IRQ Resources. To do this, select IRQ Resources and press E
NTER. A new
menu will appear (BIOS Menu 14).
To Next Page
Loading...
Need help?
General
