1-67
ROCKY-4786EVG CPU Card
67
required for warranty validation.
Use the product before you have verified that all cables and power
connectors are properly connected.
Allow screws to come in contact with the PCB circuit, connector pins, or
its components.
4.2 Unpacking
NOTE:
If any of the items listed below are missing when you unpack the
ROCKY-4786EVG CPU card, do not proceed with the installation and
contact the reseller or vendor you purchased the CPU card from.
4.2.1 Unpacking Precautions
Before you install the ROCKY-4786EVG CPU card, you must unpack the CPU card. Some
components on ROCKY-4786EVG are very sensitive to static electricity and can be
damaged by a sudden rush of power. To protect it from being damaged, follow these
precautions:
Ground yourself to remove any static charge before touching your
ROCKY-4786EVG. You can do so by wearing a grounded wrist strap at all
times or by frequently touching any conducting material that is connected
to the ground.
Handle your ROCKY-4786EVG by its edges. Do not touch the IC chips,
leads, or circuitry if not necessary.
Do not place a PCB on top of an anti-static bag. Only the inside of the bag is safe from
static discharge.
To Next Page
Loading...
Need help?
General
