WAFER-LX Motherboard
Page 24
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the
WAFER-LX may result in permanent damage to the WAFER-LX and
severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the WAFER-LX. Dry climates are especially susceptible to ESD. It is therefore
critical that whenever the WAFER-LX, or any other electrical component is handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding:- Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: When configuring the WAFER-LX, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
WAFER-LX.
Only handle the edges of the PCB:-: When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the WAFER-LX is unpacked, please do the following:
Follow the anti-static precautions outlined in Section
3.1.
Make sure the packing box is facing upwards so the WAFER-LX does not fall
out of the box.
Make sure all the components shown in Section
3.3 are present.
To Next Page
Loading...
Need help?
General
