9
Printers, copiers, multifunctionals
Preparation
Before a printer copier or multifunctional can be used in the system an Inepro terminal must be connected.
Installing a terminal at a printer, copier or multifunctional is a task that can only be executed by an Inepro Certified
Engineer, ask the vendor for such an engineer when adding or removing such machines to or from the system.
Make sure that the required data such as the IP address (or IP-range) of this terminal and the address of the server are
known by Inepro.
Make sure that a network and power outlet are available at the location of the vending machine.
The terminal is powered separately and requires an additional power outlet, and an
additional network outlet!
On site
Connect the device, and the terminal to a power outlet and their network cable(s) to a network outlet.
It is possible that the device and the terminal share a network cable.
To Next Page
Loading...