Preset Points
Description
The Preset Points option allows you to specify the val-
ues of up to three independent variables at three preset
points for recording the values of three dependent vari-
ables. Preset Points data is accessible through the RS-
232 connector on the rear panel, but there is no
provision for displaying it on the front panel. The printer
must be available to print out Preset Points data.
The Preset Points are set up to trip on a specific value of
either extension or strain. When this value is reached,
the system automatically records the values of load and
energy at those points. Figure 6-1 is a typical test curve
showing the data obtainable at preset points.
Figure 6-1. Typical Test Curve with Preset Points
Preset Points M10-94400-1
6-34
To Next Page
Loading...
