(b) Insert a socket head cap screw in each of the four
mounting holes and hand tighten.
(c) With all screws in place, tighten the screws evenly
until all are secure.
(d) Attach the sliding bracket to the pivot bracket using
the pins provided.
(e) Lightly tighten the thumbscrews (these will be tight-
ened firmly when the console is mounted on the load
frame and a comfortable viewing position has been
selected).
Mounting the Console Bracket
To mount the console on the load frame column:
(a) Place the console bracket against the side of the col-
umn (or column extension) so that the T-nuts of the
friction devices are in the grooves of the load frame
column cover.
(b) Slide the bracket up or down in the groove to a con-
venient height for comfortable operation. Tighten
both friction knobs by hand, but avoid over-tighten-
ing.
(c) Loosen the rotational securing screws and rotate the
bracket to one of four positions for a comfortable
viewing angle. Tighten the thumbscrews firmly, but
do not over-tighten.
(d) Go to the next section to install cables.
Console Connections M10-94400-1
3-4
To Next Page
Loading...
Need help?
General
