Instron 4400 Series - Printout with Strain as Independent Variable; Printout with Extension as Independent Variable

Table 6-8 shows a typical printout with Strain as the in-
dependent variable and Strain 1 as the active channel.
Table 6-9 shows a typical printout with Extension as the
independent variable. (Note that AREA is greater than
1.00 in both printouts, so the Load and Energy fields
show division by “A”.)
LB/A IN MILS LB*SI
PEAK = -1.616E02 5.469 23.54 -7.69E00
BREAK = -9.745E01 5.482 23.45 -7.69E00
PPT1 = -2.953E-01 10.00 -2.870E00
PPT2 = -2.953E-01 20.00 5.827E00
SPEED = 5.000 IN/MIN AREA = 2.00E-01
TOTAL ENERGY = -7.737E00 LB*SI MILS/A
Table 6-8. Printout with Strain as Independent Variable
LB/A IN MILS LB*SI
PEAK = -2.315E02 3.453 23.97 -4.019E02
BREAK = -2.303E02 3.466 24.00 -4.057E02
PPT1 = -1.830E02 1.000 -3.874E01
PPT2 = -1.830E02 3.00 3.095E02
SPEED = 5.000 IN/MIN AREA = 2.00E-01
TOTAL ENERGY = -7.737E00 LB*EX IN/A
Table 6-9. Printout with Extension as Independent Variable
Printer M10-94400-1
6-28