General Considerations
Installation of a basic Series 4400 testing instrument is
described in the load frame manual for the system. This
chapter describes how to access the interior of the con-
sole and install cabling for optional devices. The basic
cables, Load and Frame, are installed at the factory.
As part of the preparation for a testing routine, you
should connect any cabling required for peripheral read-
out and control accessories before powering up the sys-
tem. These accessories include strain measuring devices,
a recorder, printer and a computer. Any panels or circuit
boards required to use these accessories have usually
been installed previously at the factory.
General Considerations M10-94400-1
3-2
To Next Page
Loading...
Need help?
General
