Instron 4400 Series - Power Requirements; Strip Chart Recorder Supplies

Power Requirements
The Strip Chart Recorder is set at the factory to accept a
main power input of 120 ±10 Va.c., single phase. A 3-wire
power cable for this voltage is included. If the power source
to be used is not 120 ±10 Va.c., the power input switch on
the underside of the recorder can be set for other voltages in
the range of 100 to 240 Va.c. (refer to Table 6-2).
To adapt the Strip Chart Recorder for a different line
voltage, set the input power switch to the proper input
voltage for your location. Be sure the line fuse is the
Part Number Description Quantity
3750-135 Fan Fold Paper,
metric units
10/box
3750-137 Fan Fold Paper,
U.S. Customary
units
10/box
3750-136 Roll Paper, metric
units
10 rolls/box
2750-138 Roll Paper, U.S.
Customary units
10 rolls/box
3740-147 Pens, red
Pen 1 for all
recorders
5 pens/pkg
3740-148 Pens, black
Pen 1 for all
recorders
5 pens/pkg
Table 6-1. Strip Chart Recorder Supplies
Strip Chart Recorder M10-94400-1
6-6