the setup display. Simply press [S1] [+/–] again to return
to the count display.
The cycle limit action can be set on the front panel by
pressing [S1] [8] [1] . When the S1 and 8 are pressed,
the setup display will show “S1 8". When the 1 is
pressed following this, the current limit value will be
shown. A new value can be entered at this time.
The cycle count and the Pip count can be included in the
printout report from the printer. To enable the counter
line in the printout, press [S1] [8] [+/–], as follows:
S1–8 = disable Counter printout (default)
S1 8 = enable Counter printout
The printout line appears as:
CYCLES = 123.5 PIPS = 40.00
Cycle Counter M10-94400-1
6-40
To Next Page
Loading...
Need help?
General
