(a) When the “E” command displays, press [0] [EN-
TER]. The display shows “E 1. - -” if no error exists
in Section 1. If an error exists, a message displays
that relates to a failed test as shown in Table 8-2.
(b) Record any error message, then repeat pressing [EN-
TER] to display messages for any additional errors in
Section 1.
(c) After all error messages are shown for Section 1, the
program automatically steps to Section 2 when you
press [ENTER]. Continue the procedure, as in Steps
(a) and (b) above, for all sections through No. 8.
(d) After all error messages display for Section 8,
and you press [ENTER], the display shows “L”
for the Look command. Press [REJ] to return to
the “E” command.
(e) To escape from the Diagnostic Monitor, press “S1”
to start the Cyclic Self Test. When the Self Test
number displays, press [ENTER].
EXAMPLE NO. 2:
To display errors for a particular section:
(a) To select Section No. 3 error message list, for exam-
ple, when the “E” command displays, press [3] [EN-
TER]. The display shows “E 3. - -” if no error exists
on Section 3. If an error exists, a message displays
that relates to a failed test as shown in Table 8-2.
Error Messages M10-94400-1
8-6
To Next Page
Loading...
Need help?
General
