User Troubleshooting
10-6 CUSA EXcel Ultrasonic Surgical Aspirator System Service Manual
General Troubleshooting
Vibration—In Test mode only—
continued
Damaged handpiece 1. Connect a new handpiece to the
CUSA EXcel console and test it.
2. If the new handpiece corrects the
problem,
• Verify that the previous handpiece is
correctly assembled, and
• If it was correctly assembled, send it
to Integra for repair.
If the problem persists after you replace
the handpiece, call Integra for assistance.
Alert Causes Recommended Action
Condition Causes Recommended Action
No power at the console AC Main Switch (on the rear panel) off Turn on the AC Main Switch (on the rear
panel).
System Power Switch (front of console)
off
Turn on the System Power Switch (on the
front of the console).
Power cord not plugged in Plug the power cord into the wall
receptacle.
Wall receptacle has no power available Try another wall receptacle, or check the
operating room circuit breakers.
Power interruption to the console Power cord becomes unplugged 1. Turn off the System Power Switch
(on the front of the console).
2. Plug the power cord into the wall
receptacle.
3. When power is restored, turn on the
System Power Switch.
4. When the Wait light (flashing) turns
off, press the Prime button to make
sure the irrigation system is ready to
use.
5. Adjust the Aspiration, Irrigation,
Amplitude, and TissueSelect settings.
6. Push the Status button to change to
Run mode.
To Next Page
Loading...
Need help?
General
