Intel® Server Boards S3200SH/S3210SH TPS Design and Environmental Specifications
102 Revision 1.8
Intel Order Number: E14960-009
Table 72. AC Line Surge Transient Performance
AC Line Surge
Duration Surge Operating AC Voltage Line Frequency Performance Criteria
Continuous 10% Nominal AC Voltages 50/60Hz No loss of function or performance.
0 to ½ AC
cycle
30% Mid-point of nominal AC
Voltages
50/60Hz No loss of function or performance.
8.2.4 AC Line Fast Transient (EFT) Specification
The power supply should meet the EN61000-4-5 directive and any additional requirements in
IEC1000-4-5:1995 and the Level 3 requirements for surge-withstand capability, with the
following conditions and exceptions:
These input transients must not cause any out-of-regulation conditions, such as
overshoot and undershoot, nor must it cause any nuisance trips for any of the power
supply protection circuits.
The surge-withstand test must not produce damage to the power supply.
The supply must meet surge-withstand test conditions under maximum and minimum
DC-output load conditions.
8.3 Product Regulatory Compliance
Intended Application – This product was evaluated as Information Technology Equipment
(ITE), which may be installed in offices, schools, computer rooms, and similar commercial type
locations. The suitability of this product for other product categories and environments (such as
medical, industrial, telecommunications, NEBS (Network Equipment Building Systems),
residential, alarm systems, test equipment, and so forth), other than an ITE application, may
require further evaluation. This is an FCC Class A device. Integration of it into a Class B
chassis does not result in a Class B device.
8.3.1 Product Safety Compliance
The server board complies with the following safety requirements:
UL60950 – CSA 60950(USA / Canada)
EN60950 (Europe)
IEC60950 (International)
CB Certificate and Report, IEC60950 (report to include all country national deviations)
CE - Low Voltage Directive 73/23/EEE (Europe)
To Next Page
Loading...
Need help?
General
