Intermec EasyCoder 501 E – Installation & Operation Ed. 1 39
Chapter 5 Media Load
Peel-Off, cont.
Route the liner around the platen roller and
the tear bar, then rearwards under the print
unit.
Secure the liner to the takeup hub with the clip
(1) and wind up some of the liner so it becomes
tight (2).
10 11
1.
2.
12
Turn the printhead lift lever to “Print” posi-
tion.
13
Pull out approximately 40 cm (15 inches) of
labels and peel off the labels manually from
the liner.
40 cm/15 in
To Next Page
Loading...
