Chapter 2 — Set Up the Printer
38 PC23 and PC43 Desktop Printer User Manual
Load Media for Tear-Off Printing
Depending on the type of media you use, you may also need to install
a printer accessory. If you need to print on tag media, Intermec
recommends installing the optional thick media springs before
printing. If you need to print on linerless media, you must install the
linerless media roller accessory before printing.
1 Pull one or both of the printer latches toward the front of the
printer and lift the printer lid.
2 If there is an empty media core in the media compartment, remove
the core.
Note: When removing printed labels on linerless media, tear the label
up towards the top of the printer to prevent media jams.
To Next Page
Loading...
