Invacare Kite - Replace Remote

Invacare
®
- Kite
SERVICE MANUAL
41
8.2.5 Replace remote
Note
Replacing the remote is very easy and is not described in detail.
However, when replacing a remote in connection with the power module, please take the final
selection of the drive program into account as described in chapter 8.2.6.
Special instructions for replacing the REM24 remote
Requirements:
• To modify a drive programme you will need:
Programming software or a hand-held programming device and the installation manual,
available from Invacare®.
Note
All electronic modules are supplied with a standard drive programme. If you have performed
customer-specific modifications to the drive programme, then these will need to be recreated
manually after installing the new electronic module.
WARNING!
Every alteration to the drive programme can influence vehicle handling and the tipping
stability of the wheelchair!
• Alterations to the drive programme must only be carried out by authorised Invacare® dealers!
• Invacare® can only assume a warranty for the safe vehicle handling of the wheelchair – in
particular tipping stability - for this standard, unaltered drive programme!