8.6 Checking the cables
• Switch the electronics OFF on the remote.
• Remove the rear cover, as described in chapter 8.1.1.
• Check all cables for visible damage, crushing points or abrasion points.
• Replace damaged cables.
• Pull on each plug carefully. The plug must not come out of its socket when pulled on lightly.
• If a plug is loose, apply slight pressure to push the plug into the socket. The plug must snap in
place securely.
• Check that the plug is firmly attached to its socket.
• Remove the batteries, as described in chapter 8.4.
• Check the battery cables for visible damage, crushing points or abrasion points.
• Replace damaged cables.
• Assemble all parts again in reverse order.
• The last step is to test all functions of the vehicle.
To Next Page
Loading...
