Invacare Kite - Lighting System; Replacing Front Headlight Completely (LED Lighting Unit)

SERVICE MANUAL
Invacare
®
- Kite
52
8.7 Lighting system
8.7.1 Replacing front headlight completely (LED lighting unit)
Note
Replacing an individual LED is not possible. If there is a defect, replace the entire front headlight.
Requirements:
• Jaw spanner 7 mm
• Allen key 3 mm
• oblique pliers
• cable binder
Uninstalling head lamps:
• Switch the electronics OFF on the remote.
• Remove the rear and the middle covers, as described in chapter 8.1.1 und 8.1.2.
• Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
• Disconnect the plug (2) of the appropriate headlight from the lighting circuit board (1).
• Pull the headlight cable out of the wheelchair. If necessary, also remove the cable ties.