iPECS-MG
Hardware Description and Installation Manual Issue 1.1
98
Once the MPB has assumed normal operation, the Country Code should be verified and, if
need be, changed as described below and in the iPECS Admin Manuals.
Locate Station 100, this should be the DKT attached to the 1st station port of the
MPB DSIU.
Press the TRANS/PGM button, the On/Off or Speaker LED illuminates.
Dial ‘*’ and ‘#’, confirmation tone is heard from the speaker.
Press the TRANS/PGM button again to receive confirmation tone.
Dial 100, confirmation tone is received.
Press Flexible button 1, the display indicates the Country Code.
If the Country Code is correct, press the On/Off or Speaker button and change the
Mode switch to ON. The System is now ready for programming; refer to the iPECS-
MG Admin Manuals.
If the Country Code is not correct,
Enter the correct Country Code, refer to the Nation Code chart below.
Press the [HOLD/SAVE] button to store the entry.
Table 7.1-2 Nation Code Listing
NATION CODE NATION CODE NATION CODE
Argentina 54 Honduras 504 Peru 51
Australia 61 Hong Kong 852 Philippines 63
Azerbaijan 994 India 91 Poland 48
Bahrain 973 Indonesia 62 Portugal 351
Bangladesh 880 Iran 98 Qatar 974
Belarus 375 Iraq 964 Rumania 40
Belgium 32 Ireland 353 Russia 7
Bolivia 591 Israel 972 Saudi Arabia 966
Brazil 55 Italy 39 Senegal 221
Brunei 673 Japan 81 Singapore 65
Cameroon 237 Jordan 962 South Africa 27
Chile 56 Kenya 254 Spain 34
China(P.R.C) 86 Korea 82 Sri Lanka 94
Colombia 57 Kuwait 965 Swaziland 268
Costa Rica 506 Kyrgyzstan 996 Sweden 46
Cyprus 357 Liberia 231 Switzerland 41
Czech(Slovak) 42 Libya 218 Tajikistan 992
Denmark 45 Luxembourg 352 Telkom *27
Ecuador 593 Malaysia 60 Telstra *61
To Next Page
Loading...
