iPECS iPECS-MG - Switch and LED Functions

iPECS-MG
Hardware Description and Installation Manual Issue 1.1
44
The default clock is assigned based on the board type, KSU, and slot as below.
− Board – PRIB > BRIB2/BRIB4 > Internal Clock
− KSU – 1’st KSU > 2’nd KSU > 3’rd KSU
− Slot – Slot 1 > Slot 2 >…> Slot 18
5.3.2.1 Switch and LED Functions
Table 5.3.2.1-1 BRIB Line Mode Switch SW1
SWICTH FUNCTION ON OFF
SW1-1 Line #1 mode S-mode T-mode
SW1-2 Line #2 mode S-mode T-mode
SW1-3 Line #3 mode S-mode T-mode
SW1-4 Line #4 mode S-mode T-mode
Note
The default setting is T Mode for all switches. SW1-3 and SW1-4 are for BRIB4 only.
Table 5.3.2.1-2 BRIB Terminating Resister (100-Ohm)
SWITCH FUNCTION ON OFF
SW6-1 Line 1 TX resistor Terminate Open
SW6-2 Line 1 RX resistor Terminate Open
SW8-1 Line 2 TX resistor Terminate Open
SW8-2 Line 2 RX resistor Terminate Open
SW10-1 Line 3 TX resistor Terminate Open
SW10- 2 Line 3 RX resistor Terminate Open
SW12-1 Line 4 TX resistor Terminate Open
SW12-2 Line 5 RX resistor Terminate Open