iPECS-MG
Hardware Description and Installation Manual Issue 1.1
21
4.4.2 Wall Mounting
1. Attach the included mounting template for accurate placement to the wall, level, and
drill 12 holes.
2. Install 12 anchor plugs into the wall using the mounting template (Figure 4.4.2 1 Wall
Mounting).
3. Insert 12 included screws into the 12 anchor plugs.
4. Tighten the screws leaving about 5 mm (0.2 inches) exposed
5. Hook the Wall Bracket onto installed screws and tighten screws.
6. Install the Rack Mount brackets to each side of the KSU with the eight (8) screws
provided.
7. Attach the Wall Shelf brackets to the bottom of KSU and affix using the eight (8)
screws provided.
8. Hook the Wall Shelf brackets onto the Wall Bracket, making sure that the System
slides down securely.
9. Affix the Wall Shelf brackets to the Wall Bracket using the four (4) screws provided.
To Next Page
Loading...
