iPECS-MG
Hardware Description and Installation Manual Issue 1.1
2
improper adjustment of other controls may result in damage and will often require
extensive work by a qualified technician to restore the product to normal operation.
− If the product has been dropped or the KSU has been damaged.
− If the product exhibits a distinct change in performance
Avoid using a telephone during an electrical storm; there is a remote risk of electric
shock and serious injury from lightning.
In the event of a gas leak, do not use the telephone near the leak.
1.2 Precaution
Keep the system away from heating appliances and electrical noise generating
devices such as florescent lamps, motors and televisions. These noise sources can
interfere with the performance of the iPECS-MG System.
This system should be kept free of dust, moisture, high temperature (more than 40
degrees) and vibration, and should not be exposed to direct sunlight.
Never attempt to insert wires, pins, etc. into the system. If the system does not
operate properly, the equipment should be repaired by an authorized Ericsson-LG
service center.
Do not use benzene, paint thinner, or an abrasive powder to clean the KSU. Wipe it
with a soft cloth only.
1.2.1 Caution
This system should only be installed and serviced by qualified service personnel.
When a failure occurs which exposes any internal parts, disconnect the power
supply cord immediately and return this system to your dealer.
To prevent the risk of fire, electric shock or energy hazard, do not expose this
product to rain or any type of moisture.
To protect PCB from static electricity, discharge body static before touching
connectors and/or components by touching ground or wearing a ground strap.
WARNING
If the battery is not correctly replaced, it may explode.
Replace only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions
To Next Page
Loading...
