iPECS-MG
Hardware Description and Installation Manual Issue 1.1
Regulatory Information
Before connecting the iPECS-MG to the telephone network, you may be required to notify your
local serving telephone company of your intention to use “customer provided equipment”. You
may further be required to provide any or all of the following information:
PSTN line Telephone numbers to be connected to the system Telephone Number
Model name iPECS–MG
Local regulatory agency registration number locally provided
Ringer equivalence 1.1
Registered jack RJ–45
The required regulatory agency registration number is available from your local Ericsson-LG
representative.
This equipment complies with the following regulatory standards, that is, the safety
requirements of EN60950-1, UL 60950-1/CSA C22.2 No. 60950-1-03 and the EMC
requirement of EN55022 and EN55024.
If the telephone company determines that customer provided equipment is faulty and may
possibly cause harm or interruption in service to the telephone network, it should be
disconnected until repair can be affected. If this is not done, the telephone company may
temporarily disconnect service.
The local telephone company may make changes in its communications facilities or
procedures. If these changes could reasonably be expected to affect the use of the iPECS-MG
or compatibility with the network, the telephone company is required to give advanced written
notice to the user, allowing the user to take appropriate steps to maintain telephone service.
The iPECS-MG complies with rules regarding radiation and radio frequency emission as
defined by local regulatory agencies. In accordance with these agencies, you may be required
to provide information such as the following to the end user.
To Next Page
Loading...