iPECS-MG
Hardware Description and Installation Manual Issue 1.1
[USA/CSA]
FCC/IC Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Change or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment under FCC rules.
This device complies with part 15 /RSS-GEN of the FCC/IC rules. Operation is subject to the
following two conditions:
(1)This device may not cause harmful interference; and (2) This device must accept any
interference received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
The use of this device in a system operating either partially or completely outdoors may require
the user to obtain a license for the system according to the Canadian regulations.
CAUTION : Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user's authority to operate the
equipment.
The following safety requirements are related to USA and Canada.
1. Replaceable batteries
"CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used
Batteries According to the Instructions."
2. Separation of TNV and SELV - Pluggable A
"The separate protective earthing terminal provided on this product shall be permanently
connected to earth."
3. Leakage currents due to ringing voltage - Earthing installation instructions
1) A supplementary equipment earthing conductor is to be installed between the product or
system and earth, that is, in addition to the equipment earthing conductor in the power supply
cord.
2) The supplementary equipment earthing conductor may not be smaller in size than the
unearthed branch-circuit supply conductors. The supplementary equipment earthing
conductor is to be connected to the product at the terminal provided, and connected to earth
To Next Page
Loading...
