FETCh Subsystem
8 FETCh Subsystem
Fetch commands return measurement data that has been previously acquired.
FETCh queries do not generate new measurements, but allow additional meas-
urement calculations from the same acquired data. The data is valid until the
next MEASure or INITiate command occurs.
FETCh[:SCALar]:CURRent[:DC]?
This command is used to get the average value of the Meter current.
Group
FETCh
Syntax
FETCh[:SCALar]:CURRent[:DC]?
Arguments
None
Default Value
None
Returns
<NRf+>
Example
FETCh[:SCALar]:CURRent[:DC]?
Also see
None
Copyright © Itech Electronic Co., Ltd.
88
To Next Page
Loading...
