ITech IT8000 Series

IEEE-488 Common Commands
*ESE?
Query the value of the enable register set by the standard event status group.
The value returned is the binary-weighted sum of all enabled bits in the register.
For example, with bit 2 (value 4) and bit 4 (value 16) set, the query returns +20.
Group
None
Syntax
*ESE?
Arguments
None
Default Value
None
Returns
<NR1>
A decimal value corresponding to the binary-weighted sum of the register's bits.
The range is from 0 to 255.
Example
*ESE?
Also see
None
*ESR?
Event status event query. Reads and clears the event register for the Standard
Event Status group. The event register is a read-only register, which latches all
standard events.
• The value returned is the binary-weighted sum of all enabled bits in the
register.
Copyright © Itech Electronic Co., Ltd.
165