CONFigurable Subsystem
Also see
None
[CONFigurable:]IO:PWM:FREQuency <NRL>,
<NRf+>
This command is used to set the PWM frequency of the specified pin.
Group
CONFigurable
Syntax
[CONFigurable:]IO:PWM:FREQuency <NRL>, <NRf+>
Arguments
<NRL>, <NRf+>
0 to 6, MINimum|MAXimum|DEFault|<value>
Value range: 2 to 21KHz
Default Value
0, 0
Returns
None
Example
Set the PWM frequency of the pin 1 to 100Hz: IO:PWM:FREQ 0, 100
Also see
[CONFigurable:]IO:PWM:FREQuency? <NRL>
Copyright © Itech Electronic Co., Ltd.
47
To Next Page
Loading...
