ITech IT8000 Series

SOURce Subsystem
12 SOURce Subsystem
♦ [SOURce:]FUNCtion <CPD>
♦ [SOURce:]LOOP:SPEed <CPD>
♦ [SOURce:]FUNCtion:MODE <CPD>
♦ [SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <NRf+>
♦ [SOURce:]CURRent:SLEW[:BOTH] <NRf+>
♦ [SOURce:]CURRent:SLEW:POSitive <NRf+>
♦ [SOURce:]CURRent:SLEW:NEGative <NRf+>
♦ [SOURce:]CURRent[:OVER]:PROTection:STATe <Bool>
♦ [SOURce:]CURRent[:OVER]:PROTection[:LEVel] <NRf+>
♦ [SOURce:]CURRent[:OVER]:PROTection:DELay <NRf+>
♦ [SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf+>
♦ [SOURce:]VOLTage:SLEW[:BOTH] <NRf+>
♦ [SOURce:]VOLTage:SLEW:POSitive <NRf+>
♦ [SOURce:]VOLTage:SLEW:NEGative <NRf+>
♦ [SOURce:]VOLTage:ON[:LEVel] <NRf+>
♦ [SOURce:]VOLTage:UNDer:PROTection:STATe <Bool>
♦ [SOURce:]VOLTage:UNDer:PROTection[:LEVel] <NRf+>
♦ [SOURce:]VOLTage:UNDer:PROTection:DELay <NRf+>
♦ [SOURce:]VOLTage:UNDer:PROTection:WARM <NRf+>
♦ [SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude] <NRf+>
♦ [SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude] <NRf+>
♦ [SOURce:]POWer:PROTection:STATe <bool>
♦ [SOURce:]POWer:PROTection[:LEVel] <NRf+>
♦ [SOURce:]POWer:PROTection:DELay <NRf+>
♦ [SOURce:]POWer:SLEW[:BOTH] <NRf+>
♦ [SOURce:]POWer:SLEW:POSitive <NRf+>
♦ [SOURce:]POWer:SLEW:NEGative <NRf+>
♦ [SOURce:]VOLTage[:ON]:LATCh[:STATe] <Bool>
♦ [SOURce:]VOLTage:ON:HYSTeresis[:LEVel] <NRf+>
♦ [SOURce:]EXTern[:STATe] <Bool>
♦ [SOURce:]ACMeter:EACStage:CLEar
12.1 [SOURce:]FUNCtion <CPD>
This command is used to set the operation mode of the load.
Group
SOURce
Syntax
[SOURce:]FUNCtion <CPD>
Copyright © Itech Electronic Co., Ltd.
122