IEEE-488 Common Commands
Returns
<NR1>
Return a 1 when commands complete.
Example
*OPC?
Also see
None
*RST
Resets the instrument to pre-defined values that are either typical or safe. The
following table shows the reset state. These parameters are reset to the indi-
cated values at power-on or after *RST.
SCPI Commands *RST Initial Settings
ARB:COUNt 1
ARB:CURRent:CDWell:DWELl 0.001
ARB:FUNCtion:SHAPe CDW
ARB:FUNCtion:TYPE VOLTage
ARB:TERMinate:LAST OFF
ARB:VOLTage:CDWell:DWELl 0.001
CALibrate:STATe OFF
CURRent 0
CURRent:LIMit 1% of rating
CURRent:LIMit:NEGative -1% of rating
CURRent:MODE FIXed
CURRent:PROTection:DELay 20ms
CURRent:PROTection:STATe OFF
CURRent:SHARing OFF
CURRent:SLEW MAX
CURRent:SLEW:MAXimum ON
Copyright © Itech Electronic Co., Ltd.
169
To Next Page
Loading...
