Chapter 3 Ethernet Testing
OAM service and link layer testing
100
HST-3000 Ethernet Testing User’s Guide
6 Use the right arrow key to go to the S-OAM LTM/LTR
configuration menu, and then specifying the following:
MD Level Specify the level for the
Maintenance Domain
(MD).
The instrument will indi-
cate whether AIS for the
specified level are
detected in the traffic
stream.
LBM Type Select one of the follow-
ing:
– Unicast. Select Uni-
cast to send an LBM
to its destination
address.
– Multicast. Select Mul-
ticast to send an LBM
to a reserved multicast
MAC address.
This setting does not
appear when running
Mac-in-Mac applications.
Setting Parameters
LTM/LTR (ping) If you want to test LTM or
LTR, select Enable; other-
wise, select Disable, and
proceed to step 7.
NOTE: When you enable
this setting, a Send LTM
action is available.
Setting Parameters
To Next Page
Loading...
