Chapter 3 Ethernet Testing
OAM service and link layer testing
HST-3000 Ethernet Testing User’s Guide
101
7 Use the right arrow key to go to the L-OAM Local Config
configuration menu, and then specifying the following:
MD Level Specify the level for the
Maintenance Domain
(MD).
The instrument will indi-
cate whether AIS for the
specified level are
detected in the traffic
stream.
Setting Parameters
Link OAM State If you want to enable link
OAM, select On; other-
wise, select Off, and pro-
ceed to step 8.
Mode Select one of the follow-
ing:
– Active. Select Active if
you want the instru-
ment to automatically
discover and monitor
the peer on the link.
– Passive. Select Pas-
sive if you want the
peer to initiate the dis-
covery process.
Vendor OUI Specify the Vendor OUI
(Organizationally Unique
Identifier) for the instru-
ment.
Setting Parameters
To Next Page
Loading...
