JDS Uniphase HST-3000 - Page 124

Chapter 3 Ethernet Testing
OAM service and link layer testing
102 HST-3000 Ethernet Testing User’s Guide
8 Use the right arrow key to go to the L-OAM Defects
configuration menu, and then specifying the following:
Vendor Specific Info Enter the value used to
differentiate the vendor’s
product models or ver-
sions. Entry of a value is
optional.
Max PDU Size Specify the largest OAM
PDU size.
Unidirectional Select Yes to advertise
that the instrument pro-
vides unidirectional sup-
port; otherwise, select No.
Link Events Select Yes if the instru-
ment supports Link Event
interpretation; otherwise,
select No.
Remote Loopback Select Yes if the instru-
ment supports OAM
remote loopback mode;
otherwise, select No.n
frames that are not OAM
PDU or pause frames to
its peer), select Yes; oth-
erwise, select No.
Variable Retrieval Select Yes if the instru-
ment can send Variable
Response OAM PDU; oth-
erwise, select No.
Setting Parameters
Link Fault If you want to indicate to
the peer a fault has
occurred, select Yes; oth-
erwise, select No.
Setting Parameters