Chapter 4 IP Testing
Establishing a PPPoE session
132
HST-3000 Ethernet Testing User’s Guide
6 Do one of the following:
– If the HST is emulating a PPPoE client, proceed to
step 7. The unit will use a static IP address.
– If the HST is emulating a PPPoE server, go to the IP
Init menu, and then specify the following settings:
Password Enter the password for the user
name that you specified. Remember
passwords are often case-sensitive.
Use Service Name – Yes. Select Yes if you want to
specify a service name. If you
specify a service name, your unit
will only attempt to establish a
PPPoE session with the service
you specify.
– No. Select No if you do not want
to specify a service name.
Service Name If you selected Yes as the Use Ser-
vice Name setting, specify the name.
The default service name is “HST”.
Settings Parameters
Local IP Enter the source IP address for
traffic generated by your unit.
This address is used as the
remote IP address for the
PPPoE client.
Subnet Mask Enter the subnet mask.
Remote IP Enter remote IP address for the
HST server. This address is
used as the local (source) IP
address on the client side of the
connection.
Settings Parameters
To Next Page
Loading...
