Chapter 4 IP Testing
Establishing a PPPoE session
HST-3000 Ethernet Testing User’s Guide
133
7 If you need to specify other settings for the test, use the
left and right arrow keys to go to the appropriate configu-
ration menu; otherwise, press the Home button, and then
do the following:
a Press the Action soft key, and then select Log-On.
The unit discovers the MAC address of the PPPoE
peer, and then uses the MAC address in combination
with a session ID to uniquely identify the session.
b Observe the messages and events associated with the
PPPoE login process in the Status Bar, the Message
Log and the IP Config result category. For a list of
potential messages, see
“PPPoE messages” on
page 134.
The PPPoE session is established. The HST will continuously
send PPP echoes and replies to keep the session estab-
lished.
To Next Page
Loading...
