Chapter 8 SAMComplete Testing
Specifying settings
238
HST-3000 Ethernet Testing User’s Guide
8 If running a L3 application, select Network Settings IP,
and then specify the following settings:
Frame Length Select one of the following:
– A predefined length
– Random
– Undersized, and then specify
the frame length
– User Defined, and then spec-
ify the frame length
– Jumbo Frame, and then
specify the frame length
Encapsulation – None.
– VLAN. If you select VLAN, be
certain to specify the VLAN
ID and Priority.
– Q-in-Q. If you select Q-in-Q,
be certain to specify the
CVLAN (customer VLAN) and
SVLAN (service provider
VLAN) settings.
Copy All Settings
(multi-stream applica-
tion only)
Specify whether these service
settings should be copied and
applied to all services.
Setting Description
Service Number
(multi-stream appli-
cation only)
Select which service to configure:
1-8
Service Name
(multi-stream appli-
cation only)
Enter the name of the service.
Destination IP Enter the destination IP address
for traffic generated by your unit.
Setting Parameters
To Next Page
Loading...
