Chapter 8 SAMComplete Testing
Specifying settings
HST-3000 Ethernet Testing User’s Guide
239
9 Select SLA Thresholds, and then specify the following
settings:
Time To Live Specify the time after which a
packet can be deleted by any
device on a circuit as a number of
hops. The default time to live set-
ting is 64 hops.
TOS/DSCP Enter a number representing the
type of service in a binary format,
or select a DSCP name.
Copy All Settings
(multi-stream appli-
cation only)
Specify whether these service
settings should be copied and
applied to all services.
Protocol
(single-stream appli-
cation only)
(Read only field) The
protocol
ID for the data in the frames using
a 2 byte hexadecimal format.
Tx Payload
(single-stream appli-
cation only)
Acterna or Fill Byte
Fill Byte (if Tx Pay-
load is Fill Byte)
Specify the fill byte using hexa-
decimal format.
Acterna Payload (if
Tx Payload is
Acterna)
Specify whether the Acterna Pay-
load is BERT pattern or Fill Pat-
tern.
Fill Pattern (if Acterna
Payload is Fill Pat-
tern)
Specify the fill byte using hexa-
decimal format, up to 64 bytes.
Setting Description
Service Number
(multi-stream applica-
tion only)
Select which service to configure:
1-8
Service Name Enter the name of the service.
Setting Description
To Next Page
Loading...
