Chapter 8 SAMComplete Testing
Specifying settings
240
HST-3000 Ethernet Testing User’s Guide
10 From the SAMComplete Settings list, select Settings
Overview. A table appears that provides all settings for all
services. Use the right and left arrows to view more of the
table.
CIR Committed Information Rate. The
threshold used to indicate the
maximum sustained throughput
guaranteed by the SLA. If the CIR
is 0, the CIR test is skipped.
EIR Excess Information Rate. The
threshold used to indicate the
maximum sustained throughput
allowed by the SLA by which a
service can exceed the CIR. The
throughput between CIR and EIR
is not guaranteed. If the EIR is 0,
the EIR test is skipped.
Policing Selects whether policing test
should be enabled. If enabled,
each stream is transmitted at a
pre-computed value >= (CIR+EIR)
and test declared as success if
received rate is below
(CIR+EIR+M).
M Value If Policing is On, specify the toler-
ance, or delta, in traffic rate which
is allowed to be received above
CIR+EIR before declaring a polic-
ing failure.
Frame Loss The maximum frame loss rate
(lost frames / total frames)
allowed.
Frame Delay The maximum allowed average
delay/latency.
Delay Variation The maximum allowed frame
delay variation
or jitter.
Setting Description
To Next Page
Loading...
