Chapter 1 Getting Started
Connectors
HST-3000 Ethernet Testing User’s Guide
9
100M optical signals, and two RJ-45 connectors are provided
on the left side of the SIM for 10/100/1G electrical signals (see
Figure 1 on page 9).
Table 8 on page 10 describes the connectors on the Ethernet
SIM.
Table 8 describes the connectors on the Ethernet SIM. For
additional input and output specifications, see Appendix B.
NOTE:
When testing 1G or 100M optical signals, be certain to use
a JDSU supported SFP. If you use a single-mode SFP, be
certain to attenuate the signal.
For a list of currently supported SFPs, contact your JDSU
TAC representative or your local JDSU sales office. You
can also contact JDSU through the company web site,
www.jdsu.com.
Figure 1 Ethernet interface connectors
Optical SFP connectors
Electrical RJ-45 Connectors
To Next Page
Loading...
