Appendix A Test Results
Auto-Neg Stats results
298
HST-3000 Ethernet Testing User’s Guide
Table 36 describes the results that appear in the Auto-Neg
Status category when testing 1G or 100M optical Ethernet
service.
Link Advt. Status Indicates that the HST has received a
valid auto-negotiation capability adver-
tisement from the Ethernet link partner
and sent an acknowledgement.
Link Config ACK Indicates that the Ethernet link partner
has acknowledged the receipt of a valid
auto-negotiation capability advertise-
ment from the HST.
Remote Fault If supported by the Ethernet link part-
ner, indicates a reason for auto-negoti-
ation failure. If auto-negotiation
succeeded, the result will read “NO”.
Speed (Mbps) Indicates the negotiated speed setting
for the link (10, 100, or 1000 Mbps).
Table 36 Optical Auto-Neg Stats test results
Result Description
Flow Control Indicates the negotiated flow control
capabilities.
Full-duplex Indicates that the Ethernet link partner
is full duplex capable.
Half-duplex Indicates that the Ethernet link partner
if half duplex capable.
Link Advt. Status Indicates that the HST has received a
valid auto-negotiation capability adver-
tisement from the Ethernet link partner
and sent an acknowledgement.
Table 35 Electrical Auto-Neg Stats test results
Result Description
To Next Page
Loading...
